Fixaball 8mm 10mm Sleeve Masonry Anchor Countersunk Pozi Zinc

For flush fixing into masonry, the Fixaball countersunk sleeve masonry anchor is zinc plated and offered in 8mm and 10mm sizes. It suits use in brick, block, concrete and stone, with a countersunk head that sits neatly within a countersunk hole on visible surfaces.

This expansion anchor has a thin-walled sleeve and is suitable for concrete, stone, brickwork, perforated bricks and dense concrete blocks. The diagonal slot pulls the small gaps down to create a positive clamping force through the fixture. Zinc-plated construction is intended for dry conditions.

Available options

• 8mm/M6 x 60mm
• 8mm/M6 x 85mm
• 10mm/M8 x 75mm
• 10mm/M8 x 100mm

Key features

• Diameter options: 8mm and 10mm
• Material and finish: zinc plated
• Countersunk head
• Suitable for brick, block, concrete and stone
• Also suitable for brickwork, perforated bricks and dense concrete blocks
• Pozidrive size: PZ 3

Sizing

• 8mm/M6 x 60mm
• 8mm/M6 x 85mm
• 10mm/M8 x 75mm
• 10mm/M8 x 100mm

Care and maintenance

Use in dry conditions to maintain reliability.

Safety information

• Using a zinc sleeve anchor in wet conditions will negatively affect reliability and can cause failure in a relatively short time.
• Drill the correct size hole, clean the hole, place the anchor in the hole, then set the anchor by tightening the nut.

Rackhams Reference : FIZ6CMW7K8