Fixaball 8mm Sleeve Masonry Anchors ZYP Nut Type

For dry internal masonry fixings, these Fixaball sleeve anchors use an 8mm diameter sleeve with an M6 thread and zinc-plated finish. The nut type expansion anchor suits concrete, stone, brickwork, perforated bricks and dense concrete blocks, with a thin-walled sleeve and diagonal slot that allows the sleeve to pull down as the nut is tightened.

Available in 40mm, 65mm and 85mm lengths, this range is intended for securing fixtures into brick, block, concrete and stone where a zinc-plated anchor is appropriate.

Key features

• 8mm diameter sleeve anchor
• M6 thread diameter
• Zinc-plated finish
• Nut type sleeve anchor
• Suitable for concrete, stone, brickwork, perforated bricks and dense concrete blocks
• Thin-walled sleeve with diagonal slot for expansion when tightened

Specifications

• Anchor hole size: 8mm
• Fixture hole size: 10
• Thread diameter: M6

Sizing

• 8 x 40
• Anchor length: 40mm
• Max. fixture thickness: 12
• Minimum hole depth: 35
• 8 x 65
• Anchor length: 65mm
• Max. fixture thickness: 37
• Minimum hole depth: 40
• 8 x 85
• Anchor length: 85mm
• Max. fixture thickness: 50
• Minimum hole depth: 40

Care and maintenance

Use in dry conditions. Wet conditions will affect reliability and shorten service life.

Safety information

• Drill the correct size hole.
• Clear and clean the hole before installation.
• Avoid over-tightening the nut.

Rackhams Reference : DV759314IQ