Fixaball Chemical Anchor Sleeve Plastic Nylon with Stud Alignment Collar

For hollow masonry fixings, the Fixaball chemical anchor sleeve uses a plastic nylon mesh body with a stud alignment collar. The mesh structure allows resin to pass into the voids of the substrate while helping to spread the load of the anchor stud.

Suitable for slab, sand-lime brick, brick and lightweight concrete block, it supports installation in hollow substrates and helps control resin use. Hole cleaning is not necessary.

Available options

• 12mm diameter x 50mm length
• 15mm diameter x 85mm length
• 20mm diameter x 85mm length

Key features

• Plastic nylon mesh sleeve
• Stud alignment collar
• For slab, sand-lime brick, brick and lightweight concrete block
• Helps control resin consumption
• Hole cleaning is not necessary

Specifications

• Suitable threaded bar: M8
• Suitable threaded bar: M10, M12
• Suitable threaded bar: M16

Sizing

• Sleeve diameter 12mm, sleeve length 50mm, hole diameter 12mm, minimum hole depth 80mm
• Sleeve diameter 15mm, sleeve length 85mm, hole diameter 16mm, minimum hole depth 110mm
• Sleeve diameter 20mm, sleeve length 85mm, hole diameter 22mm, minimum hole depth 110mm

Care and maintenance

• After the resin has set, do not over-tighten the fixing.

Safety information

• Not suitable for cracked hollow masonry.
• Drill the hole square and remove large chippings.
• Insert the sleeve so the top lip sits flush with the substrate surface.
• Apply the resin to 100% of the hole depth.
• Keep the stud centred within the sleeve during installation.

Rackhams Reference : UB5FEE4KNW