x2 26MM DIN1142 Wire Rope Grips Zinc Plated - Cable Clamp Fixing Bulldog Lifting

Designed for dependable rigging and lifting assemblies, these DIN1142 wire rope grips are zinc plated and sized to suit 26mm wire. Supplied as a quantity of 2, they are intended for creating loops in a wire rope assembly or for making a temporary join when required, whether used on board boats in a rigging set-up or in similar land-based applications.

Manufactured from mild steel with a zinc coating for corrosion resistance, each grip should be installed by a qualified person. For best results, grease the threads on the nuts and bolts before fitting, keep spacing between grips at least 6 times the diameter of the rope, and ensure correct orientation with the U-bolt placed on the unloaded end of the rope. Tighten each nut evenly in turn to achieve the recommended torque settings, then re-check after 24 hours, after the first application of load, and periodically during service.

Key features

• DIN1142 wire rope grips for rigging and lifting assemblies
• Suitable for 26mm wire
• Zinc plated finish
• Quantity: 2
• Designed to create loops in wire rope assemblies or form temporary joins
• Suitable for use on board boats in rigging set-ups or similar land applications

Sizing

• A: 50mm
• B: 27mm
• C: 40mm
• D: 20mm
• E: 111mm
• F: 51mm
• G: 86mm

Safety information

• Install by a qualified person
• Grease the threads on nuts and bolts prior to fitting
• Keep spacing between grips at least 6 times the diameter of the rope
• Fit with correct orientation: place the U-bolt on the unloaded end of the rope
• Tighten each nut evenly and in turn to achieve the recommended torque settings
• Leave unused for 24 hours, then re-check torque settings and re-tighten if necessary
• After first application of load, re-check torque settings and re-tighten if necessary
• Periodically check torque settings during service

Please note: Colours may appear slightly different in person than on your screen.