ATEK 100cm Monobloc Kitchen Tap Flexible Hose Connectors 10mm x 18.6mm Flexi Tails Pair

From ATEK, this pair of monobloc flexible tap hose connectors is designed for compatible kitchen mixer and basin taps where extra reach is needed beneath the sink. Each hose measures approximately 100cm, making them useful when the tap and water supply connections are positioned further apart than standard shorter connectors can comfortably accommodate.

The flexible metal-braided construction helps protect the hose while allowing easier routing around suitable plumbing components. One end features an approximately 10mm male threaded connector with a rubber O-ring, while the opposite end has an approximately 18.6mm female hexagonal connector. Red and blue tracer markings provide a clear visual reference when organising hot and cold water connections, whether for replacement of compatible flexi tails or for a new compatible installation.

Key features

• Supplied as a matching pair
• Approximately 10mm male threaded connection with rubber O-ring
• Approximately 18.6mm female hexagonal connection
• Flexible metal-braided outer construction
• Red and blue tracer markings for hot and cold identification
• Suitable for compatible monobloc kitchen mixer and basin taps
• Designed for under-sink routing

Sizing

• 100cm hose length per connector
• Approximately 10mm male connection
• Approximately 18.6mm female connection

What's included

2 x flexible tap hose connectors

Please note

Please check compatibility with your existing installation before ordering.

Care

• Do not stretch the hose between connection points
• Avoid unnecessary tight loops or coils where excess hose length is present
• Do not kink, twist, crush or sharply bend the hose
• Keep the braided exterior away from sharp edges that could cause abrasion or damage

Rackhams Reference : PLUJMS674N