x4 13MM DIN1142 Wire Rope Grips Zinc Plated - Cable Clamp Fixing Bulldog Lifting

Designed for secure wire rope assemblies, these DIN1142 wire rope grips from Rackhams are a practical choice for creating loops or making temporary joins where a dependable hold is required. Supplied as a set of 4, each grip suits 13mm wire rope and features a zinc plated finish.

Suitable for use on board boats in rigging set-ups, as well as similar applications on land, these grips are intended for assemblies designed for lifting purposes. For correct performance and safety, installation should be carried out by a qualified person, with careful attention to fitting, orientation and ongoing checks during service.

Key features

• DIN1142 wire rope grips for 13mm wire rope
• Set of 4 grips
• Zinc plated finish
• Designed to create loops in a rope assembly or for temporary joins
• Suitable for rigging set-ups on boats and similar land-based applications
• Intended for lifting-purpose assemblies

Sizing

• A=31mm
• B=16.5mm
• C=29mm
• D=12mm
• E=63mm
• F=30mm
• G=54mm

Safety information

• Install by a qualified person
• Before fitting, grease the threads on the nuts and bolts
• Keep spacing between grips at least 6 times the diameter of the rope
• Ensure correct orientation: place the U-bolt on the unloaded end of the rope
• Tighten each nut evenly and in turn to achieve the recommended torque settings
• Leave unused for 24 hours, then re-check torque settings and re-tighten if required
• After the first application of load, re-check torque settings and re-tighten if required
• During service, periodically check torque settings

Please note: Colours may appear slightly different in person than on your screen.

Rackhams Reference : F29C4ZH972