x4 8MM DIN1142 Wire Rope Grips Zinc Plated - Cable Clamp Fixing Bulldog Lifting

Designed for secure wire rope assemblies, these DIN1142 wire rope grips from Rackhams are a practical choice for creating loops or making temporary joins where a dependable clamp is required. Supplied as a set of 4, each grip suits 8mm wire rope and features a zinc-plated finish.

Suitable for rigging set-ups on board boats or similar applications on land, these grips are intended for assemblies designed for lifting purposes. For correct performance and safety, installation should be carried out by a qualified person, following the recommended fitting and re-check guidance.

Key features

• DIN1142 wire rope grips for 8mm wire rope
• Zinc-plated finish
• Pack quantity: 4
• Suitable for creating wire rope loops and temporary joins
• Suitable for boat rigging set-ups and similar land-based applications
• Intended for lifting-purpose assemblies

Sizing

• A: 22mm
• B: 11.5mm
• C: 21mm
• D: 8mm
• E: 45mm
• F: 20.5mm
• G: 38mm

Safety information

• Install by a qualified person
• Before fitting, grease the threads on the nuts and bolts
• Keep spacing between grips at least 6 times the diameter of the rope
• Orientate correctly: place the U-bolt on the unloaded end of the rope
• Tighten each nut evenly and in turn to achieve the recommended torque settings
• Leave unused for 24 hours, then re-check torque settings and re-tighten if necessary
• After the first application of load, re-check torque settings and re-tighten if necessary
• During service, periodically check torque settings

Rackhams Reference : 91BGYSKDU4