34MM Wire Rope Grips x2 - DIN741 Commercial Cable Clamp

Designed for securing and forming terminations in wire rope, these DIN741 commercial wire rope grips provide a practical solution for creating loops in 32mm wire rope. Supplied as a pack of 2, they’re suited to a wide range of applications referenced in the source, including use aboard boats, in public areas and for yacht rigging.

A galvanised finish is specified to offer excellent corrosion resistance, helping support use in demanding environments where exposure is a consideration. For best results, correct fitting and ongoing checks are required, including correct orientation of the U-bolt and periodic re-tightening during service.

Key features

• DIN741 commercial wire rope grips
• Suits 32mm wire rope
• Galvanised finish
• Quantity: 2
• Product code: SFCOMG32
• Product weight: 1.41KG

Sizing

• A: 60.5mm
• B: 35mm
• C: 38mm
• D: 15mm
• E: 121mm
• F: 47mm
• G: 79mm

Safety information

• Grease the threads on the nuts and bolts before fitting
• Allow at least 6 times the rope diameter between grips
• Fit with correct orientation: place the U-bolt on the unloaded end of the rope
• Tighten each nut evenly and in turn to achieve the recommended torque settings
• Leave unused for 24 hours, then re-check torque settings and re-tighten if required
• After the first application of load, re-check torque settings and re-tighten if required
• During service, check torque settings periodically