x4 10MM DIN1142 Wire Rope Grips Zinc Plated - Cable Clamp Fixing Bulldog Lifting

Designed for rigging and lifting assemblies, these DIN1142 wire rope grips from Rackhams provide a practical way to secure 10mm wire rope when forming loops or creating a temporary join. Made from mild steel with a zinc coating for corrosion resistance, they suit use on board boats as part of a rigging set-up, as well as similar applications on land. Supplied as a pack of 4, each grip features a zinc plated finish.

Key features

• DIN1142 wire rope grips for 10mm wire rope
• Quantity: 4
• Material: mild steel with a zinc coating
• Zinc plated finish
• Suitable for creating loops in wire rope assemblies
• Suitable where a temporary join is required
• Intended for assemblies designed for lifting purposes

Sizing

• A=24mm
• B=14mm
• C=18.5mm
• D=8mm
• E=45mm
• F=20.5mm
• G=38mm

Safety information

• Install by a qualified person
• Before fitting, grease the threads on the nuts and bolts
• Keep spacing between grips at least 6 times the diameter of the rope
• Ensure correct orientation: place the U-bolt on the unloaded end of the rope
• Tighten each nut evenly and in turn to achieve the recommended torque settings
• Leave unused for 24 hours, then re-check torque settings and re-tighten if required
• After first application of load, re-check torque settings and re-tighten if required
• During service, periodically check torque settings

Please note: Colours may appear slightly different in person than on your screen.

Rackhams Reference : 6VI4NG4LPS