Fixaball 20mm Sleeve Masonry Anchors ZYP Nut Type

For masonry fixings in dry interior conditions, these Fixaball sleeve anchors use a zinc plated finish and a hex nut ‘NUT’ type configuration. They are suitable for use in concrete, stone, brickwork, perforated bricks, dense concrete blocks, brick and non-porous stone.

The thin-walled sleeve expands as the nut is tightened, with a diagonal slot that pulls down small gaps and applies clamping force through the fixture. Each anchor has an M16 thread diameter and a 20mm drilled hole size, with length options of 80mm, 110mm and 150mm.

Key features

• 20mm diameter sleeve masonry anchor
• M16 thread diameter
• Zinc plated finish
• Hex nut ‘NUT’ type
• Suitable for concrete, stone, brickwork, perforated bricks, dense concrete blocks, brick and non-porous stone

Specifications

• Anchor hole size: 20mm
• Fixture hole size: 24
• Minimum hole depth: 70

Available options

• 20 x 80
• 20 x 110
• 20 x 150

Sizing

• 20 x 80
• 20 x 110
• 20 x 150

Care and maintenance

Use in dry conditions. Wet conditions will negatively affect reliability and shorten service life.

Safety information

• Drill the correct size hole.
• Clear and clean the hole before installation.
• Set the anchor by tightening the nut.
• Avoid over-tightening the nut.

Rackhams Reference : 3GPRW3Y5JG