Fixaball M10 Bolt Shield Anchor Masonry Concrete Brick Stone

For masonry fixing into concrete, brick and stone, this Fixaball heavy duty shield anchor pairs an M10 threaded loose hex bolt with a masonry shield. It has a zinc finish and a high tensile 8,8 specification, with a 16mm shield hole size and installation data provided for accurate fitting.

Suitable where a secure mechanical anchor fixing is required, the bolt is tightened with a 17mm spanner and installed to the stated depth and torque values.

Available options

• Maximum fixing thickness: 10mm
• Maximum fixing thickness: 25mm
• Maximum fixing thickness: 50mm
• Maximum fixing thickness: 75mm

Key features

• M10 thread diameter
• Zinc finish
• High tensile 8,8
• Suitable for concrete, brick and stone

Specifications

• Shield hole size: 16mm
• Hole diameter: 16
• Hole depth: 65
• Fixture/material clearance hole: 11 – 12
• Centre spacing between holes: 180
• Minimum distance from edge of material: 120
• Tensile/pull load: 6. 2 k/N (tonnes)
• Shear load: 6. 1 k/N (tonnes)
• Torque to tighten: 27 Nm
• Socket size guide: M10 - 17mm spanner

Safety information

• Clean the hole using an appropriate sized brush before installation.
• Installation temp is 0; make sure water does not seep into the hole, as expansion from water to ice could crack the concrete.
• Under wet conditions, use a specified injection resin.
• Introduce the anchor through the material to be fixed into the hole up to the embedment depth according to the stated values, and use a hammer to ensure the required depth.
• Do not apply any intermediate layer between the material to be fixed and the washer, including sealing products.
• Apply the specified torque with a torque wrench.
• If the holes on the material to be fixed have a bigger diameter than required, insert a thicker washer of a bigger diameter. This procedure does not ensure correct distribution of shear loads amongst all anchors of the same group, and the shear load is applied only to anchors with a correct diameter on the material to be fixed.
• When drilling holes, respect the specified minimum depth and diameters.
• Holes must be square to the surface of the base material for safety during installation.
• If rebar is encountered, abort the hole, repair with high quality mortar, and create a new hole no less than twice the diameter of the shield anchor away.

Rackhams Reference : 1FUBBMKZPU