Fixaball M10 Throughbolts A2 Stainless Steel Heavy Duty Masonry Concrete Anchor

For masonry and concrete fixings, these Fixaball M10 throughbolts provide a stainless steel expansion anchor in A2/304 grade. They are suitable for use in non-cracked concrete, masonry including brick and blocks, and non-porous stone.

The through-fixing design uses a hole diameter that matches the bolt diameter, allowing the fixing to pass through the fixture once it is positioned. This makes them suitable for securing awkward fixtures without removing and repositioning during installation. The anchor is torque-controlled and suitable for use in concrete over C20/25 strength.

Available options

• 10mm x 60mm
• 10mm x 80mm
• 10mm x 100mm
• 10mm x 125mm
• 10mm x 150mm
• 10mm x 175mm

Key features

• Diameter: M10
• Material and finish: A2/304 stainless steel
• Suitable for non-cracked concrete, masonry, and non-porous stone
• Torque-controlled anchor
• Hole diameter matches the bolt diameter
• Suitable for reduced embedment to avoid contact with rebars and reinforcement cages

Specifications

• Suitable for use in concrete over C20/25 strength
• Installation temperature range for base material: -5 / + 40 ºC
• 80 ºC for a short period of time
• A2/304 has a similar tensile strength to 8.8 high tensile steel

Sizing

• Anchor hole size: 10mm
• Anchor length: 60mm
• Anchor hole size: 10mm
• Anchor length: 80mm
• Anchor hole size: 10mm
• Anchor length: 100mm
• Anchor hole size: 10mm
• Anchor length: 125mm
• Anchor hole size: 10mm
• Anchor length: 150mm
• Anchor hole size: 10mm
• Anchor length: 175mm

Safety information

• Check the concrete strength, grade, and edge distance before installation.
• The concrete base must be compact and crack free.
• Minimum installation depth values must always be respected for anchor depth, anchor-to-anchor distances, and anchor-to-edge distances.
• Drill to the specified minimum depth and diameter, perpendicular to the base material surface.
• Take special care near reinforcement areas to avoid damage.
• Clean holes thoroughly to remove dust and debris with a suitably sized brush.
• When temperature is below 0ºC, make sure water does not seep into the hole.
• Do not apply any intermediate layer between the material to be fixed and the washer.
• Apply the specified torque with a torque wrench.

Rackhams Reference : SAETSSMEQE