Fixaball M10 Throughbolts Galvanised Heavy Duty Masonry Concrete Anchor

For concrete, masonry and non-porous stone fixings, this Fixaball M10 throughbolt provides a torque controlled anchor in a hot dip galvanised finish. It is suitable for use in concrete over C20/25 and for fixing into non-cracked concrete, brick, blocks and similar dense substrates.

The hot dipped galvanised coating is applied to a minimum of 45 microns. The fixing passes through the fixture once positioned, with hole sizes matching the fixing diameter. Reduced embedment options are available to help avoid contact with rebars or reinforcement cages.

Key features

• M10 throughbolt
• Hot dip galvanised finish
• Hot dipped galvanised to a minimum of 45 microns
• Suitable for non-cracked concrete, masonry and non-porous stone
• Suitable for use in concrete over C20/25
• Torque controlled anchor
• Cold formed body for consistent dimensional accuracy and material stability

Specifications

• Installation temperature range for base material: -5 / + 40 ºC
• 80 ºC for a short period of time
• Anchor hole size: 10mm

Sizing

• Available lengths: 60mm, 70mm, 85mm, 105mm, 125mm
• M10: anchor diameter 10, anchor length 65, max. fixture thickness 5, hole diameter 11
• M10: anchor diameter 10, anchor length 80, max. fixture thickness 20, hole diameter 11
• M10: anchor diameter 10, anchor length 85, max. fixture thickness 25, hole diameter 11
• M10: anchor diameter 10, anchor length 95, max. fixture thickness 35, hole diameter 11
• M10: anchor diameter 10, anchor length 115, max. fixture thickness 55, hole diameter 11
• M10: anchor diameter 10, anchor length 130, max. fixture thickness 70, hole diameter 11
• M10: anchor diameter 10, anchor length 140, max. fixture thickness 80, hole diameter 11
• M10: anchor diameter 10, anchor length 150, max. fixture thickness 90, hole diameter 11
• M10: anchor diameter 10, anchor length 180, max. fixture thickness 120, hole diameter 11

Safety information

• Check the concrete strength before installation to ensure the class is suitable.
• The concrete base must be compact with insignificant porosity.
• Minimum installation depth values must always be respected for anchor depth, anchor-to-anchor distances and anchor-to-edge distances.
• Drill to the specified minimum depth and diameter, perpendicular to the base material surface.
• Take special care when drilling near reinforcement areas to avoid damage.
• If drilling is aborted after encountering reinforcement, drill a new hole at a minimum distance of at least twice the aborted drill hole diameter, unless the aborted hole is filled with high-resistant mortar.
• Clean holes thoroughly to remove dust and debris using a suitably sized brush.
• When temperature is below 0ºC, ensure water does not seep into the hole.
• Insert the anchor through the material to be fixed up to the embedment depth according to the table values.
• Do not apply any intermediate layer between the material to be fixed and the washer, including sealing products.
• Apply the specified torque with a torque wrench.
• If the holes in the material to be fixed are larger than required, a thicker washer of larger diameter is necessary.
• A larger washer does not ensure correct distribution of shear loads amongst all anchors in the same group.

Rackhams Reference : HLUHFCI6UB