Fixaball M10 Wall Shield Anchor Stud Nut Masonry Concrete Brick

For heavy-duty masonry fixings, this Fixaball M10 wall shield anchor uses a projecting stud with nut and washer for securing fixtures into concrete, brick, block and non-porous stone. The protruding threaded bar helps locate materials during installation, making it suitable where items need to be held in place as they are fixed.

The anchor comprises a 3-part shield, a high tensile grade 8.8 threaded bar, nut and washer. Tightening the nut expands the shield at 3 points within the substrate. Maximum joining thicknesses available are 10mm, 30mm, 50mm and 70mm.

Key features

• M10 thread diameter
• Heavy-duty masonry shield anchor with projecting stud
• High tensile grade 8.8 threaded bar
• 3-part shield expands at 3 points as the nut is tightened
• Suitable for concrete, brick, block and non-porous stone

Specifications

• Hole diameter: 16
• Hole depth: 65
• Fixture/material clearance hole: 11 – 12
• Center spacing between holes: 180
• Minimum distance from edge of material: 120
• Tensile/pull load: 6.2 k/N (tonnes)
• Shear load: 6.1 k/N (tonnes)
• Torque to tighten: 27 Nm

Available options

• Maximum joining thickness: 10mm
• Maximum joining thickness: 30mm
• Maximum joining thickness: 50mm
• Maximum joining thickness: 70mm

Care and maintenance

• Take care not to damage the thread during installation.
• Clean the drilled hole with a brush and air pump before fitting.

Safety information

• All specifications are true with correct installation.
• The fixing performance depends on the grade of material it is fixed into.

Rackhams Reference : 4I3GAPHKDH