Fixaball M10 Throughbolts A4 Stainless Steel Masonry Anchor ETA Option 7

For heavy-duty fixing into non-cracked concrete, masonry and non-porous stone, the Fixaball M10 throughbolt anchor is manufactured from A4/316 stainless steel. This torque controlled masonry anchor suits concrete over C20/25 strength and uses a through-fixing format, allowing the fixing to pass through the fixture with the hole diameter matching the bolt diameter.

A4/316 stainless steel is marine grade and suited to locations exposed to constant water, air and chemical contact, including salt exposure. The range includes multiple anchor lengths to suit different fixture thicknesses and installation requirements.

Key features

• M10 diameter
• A4/316 stainless steel
• ETA Approved Option 7
• Suitable for non-cracked concrete, masonry, brick, blocks and non-porous stone
• Torque controlled anchor
• Suitable for concrete over C20/25 strength

Specifications

• Installation temperature range for base material: -5 / + 40 ºC
• 80 ºC for a short period of time
• Hole diameter matches the bolt diameter

Available options

• 10mm hole size, 60mm anchor length
• 10mm hole size, 85mm anchor length
• 10mm hole size, 105mm anchor length
• 10mm hole size, 125mm anchor length
• 10mm hole size, 175mm anchor length
• 10mm hole size, 215mm anchor length

Sizing

• M10, 10, 65, 5, 11
• M10, 10, 80, 20, 10
• M10, 10, 85, 25, 15
• M10, 10, 95, 35, 25
• M10, 10, 115, 55, 45
• M10, 10, 130, 70, 60
• M10, 10, 140, 80, 70
• M10, 10, 150, 90, 80
• M10, 10, 180, 120, 110

Safety information

• Check the concrete strength, grade and edge distance before installation.
• Use only in compact, crack-free concrete.
• Minimum installation depth values must always be respected for anchor depth, anchor-to-anchor distances and anchor-to-edge distances.
• Drill to the specified minimum depth and diameter, perpendicular to the base material surface.
• Take special care near reinforcement areas to avoid damage.
• Clean holes thoroughly to remove dust and debris with a suitably sized brush.
• When temperature is below 0ºC, make sure water does not seep into the hole.
• Do not apply any intermediate layer between the material to be fixed and the washer.
• Apply the specified torque with a torque wrench.

Rackhams Reference : 3NWRAGHL3G